Hi all, I have been using SkulptOk for a little over 1 year now, love it, and have had some good successes. I have recently begun using it for laser engraving challenge coins with bas-relief imagery. However, I’m noticing that on this particular occasion, I can’t get the settings right to capture the details I want. I am generating a good depth map, but the facial image is not showing enough contrast. I have tried uploading the depth map into Lightroom and adjusting teh contrast, blacks, whites, shadows, etc. with some success, but on this particular one I am having a dickens of a time. I am also curious: if I am using a 3mm brass coin, what are the correct settings in the lithophane gebnerator min max settings? I have a general idea by teh question mark, but I am not grasping how this works in relation to the actual engraving? I am using LightBurn 2.1.04 Pro version with a Monport 60-watt fiber laser. I have usually been doing 325 lines
I was looking for an image upload section so I could share the image I am having issues with, but don’t see one.